Home > PoshPrime >

Saniflo 081 SaniAccess 2 Macerator Pump White

Saniflo 081 SaniAccess 2 Macerator Pump White




 
Retail Price: $810.00
Your Price: $688.50
Savings: $121.50


Product Availability: Usually Ships in 24 Hours or Less!!
Product Code: SANIFLO-81
Qty:

Description
 

Product Description

The Saniaccess2 is a system that is used to install a half bathroom up to 15 feet below the sewer line, or even up to 150 feet away from a soil stack. It can handle the effluent from a toilet and sink.

The Saniaccess2 is simplicity itself to install; there are just four connections.

  • The macerator/pump is connected to the spigot of a horizontal rear discharge toilet.
  • The toilet tank is connected to the water supply.
  • The macerator/pump is connected to the small diameter discharge pipe work.
  • The macerator/pump is connected to the electrical supply.

The inside of the unit comprises of a pressure chamber, which starts and stops the unit, and the motor, which drives the stainless steel macerator blades and the pump.

When the flush is activated, the water flowing into the Saniaccess2 activates a micro switch in the pressure chamber, which in turn starts the motor. The motor is sealed for life in an oil filled enclosure. A common spindle/shaft drives the impeller and the macerator blades. The moving parts therefore are kept to an absolute minimum. Water and organic waste matter enter the chamber and are reduced to slurry as the macerator blades rotate at 3600 RPM. The centrifugal force causes the reduced solids to be ejected through a grill into the container where it is picked up by the impeller pump mounted beneath the motor. The unit pumps the effluent upward to 15 feet and/or 150 feet horizontally (with gravity fall). Once the water level in the container goes down, the micro switch deactivates the unit until the flush is activated again. A normal operating cycle for Saniaccess2 takes about 10 - 15 seconds depending upon the discharge pipe run configuration; power consumption is therefore minimal.

In addition to the toilet waste, the Saniaccess2 will also discharge gray water from a sink. The wastewater will drain into the system via a 1-1/2 inlet which is located on the side of the pump housing. Note that either side connection can be used for the vent or as an inlet.

The discharge elbow on top of the unit can be turned either to the left, to the right, or towards the back, depending on the discharge installation. A non-return valve, which comes already assembled on the discharge elbow, prevents back flow into the unit.

This unit has been designed with a 1-1/2 vent connection on the side of the pump housing. All plumbing codes require connection to a vent system. Please note that the vent system should be a two-way air vent. The use of mechanical vents, air admittance valves or similar devices are not permitted as these are considered one-way air vent systems. It is also highly recommended for the macerator/pump to be connected to a Ground Fault Interrupter (GFI) circuit.

Periodic maintenance can be accomplished easily without having to disconnect the unit from either the toilet or the rest of the plumbing system. Through one service panel, a service contractor can access the electrical components as well as the level sensor mechanism of the pump. The second service panel provides ready access to the basket area around the macerating blades for easy removal of any large objects that may have been accidentally flushed.

The Saniaccess2 unit must be connected to our rear discharge toilet. This system uses much less water than a regular toilet. Note: This toilet only works in combination with Saniflo systems.

The Saniaccess2 has been certified to American and Canadian Standards. Macerating standard; US: CSA Certified & IAPMO (UPC) listed - ASME A112.3.4, CA: Macerating Standard CSA B45.9.

All items may be purchased separately. However, the Saniaccess2 works as a system and therefore a toilet bowl (083 or 087), toilet tank (005) and the macerating unit (081) need to be purchased. An optional extension pipe (030) is available for the pump to be installed behind the wall.

Additional Information





Accessories
Saniflo 083 Toilet Bowl Rear Spigot Bowl Round Front White Saniflo 005 Toilet Tank Insulated Tank w/ Fill And Flush Valves White Saniflo 087 Toilet Bowl Elongated Rear Spigot Toilet Ada Compliant 16 3/4 High White Saniflo 030 Extension Pipe Extension Pipe Between Toilet And Macerator White
Your Price: $145.35

Add
Your Price: $111.35

Add
Your Price: $173.40

Add
Your Price: $47.60

Add
Saniflo 083 Toilet Bowl Rear Spigot Bowl Round Front White Saniflo 005 Toilet Tank Insulated Tank w/ Fill And Flush Valves White Saniflo 087 Toilet Bowl Elongated Rear Spigot Toilet Ada Compliant 16 3/4 High White Saniflo 030 Extension Pipe Extension Pipe Between Toilet And Macerator White

Share your knowledge of this product. Be the first to write a review »

Browse for more products in the same category as this item:

PoshPrime
Plumbing
Brands > Saniflo
Bath > Toilets & Bidets - See More > Up Flush Toilets
Brands
Bath > Toilets & Bidets - See More
Plumbing > Pumps
Appliances
Bath